5x7cm Double Sided ESP12 ESP32 Prototyping PCB Board ESP07

🔧 5x7cm Double Sided ESP12 ESP32 Prototyping PCB Board | AuscomTech

This 5x7cm double-sided prototyping PCB board is designed for building compact WiFi, IoT, relay, sensor, and microcontroller circuits.

One side includes SMD pads for ESP-12 style modules, while the opposite side includes SMD pads for ESP32 modules, allowing the same board type to support different wireless project builds.

The surrounding prototyping area uses standard 2.54 mm hole pitch, making it compatible with common pin headers, resistors, capacitors, connectors, jumper wiring, and through-hole components.

⭐ Key Features

• Double-Sided ESP Layout – ESP-12 SMD footprint on one side and ESP32 SMD footprint on the opposite side.
• ESP07 Support – Can be used with ESP07 modules where the pad spacing and pin layout match ESP-12 style footprints.
• Standard 2.54 mm Pitch – Works with common through-hole components, headers, sockets, connectors, and prototyping wires.
• SMD Module Pads – Provides a cleaner mounting option for WiFi modules compared with loose wiring or adapter boards.
• Relay Project Ready – Suitable for adding relay modules, driver transistors, resistors, diodes, and screw terminals for control projects.
• Labelled Pin Markings – GPIO, power, reset, ADC, TX, RX, and ground markings help simplify wiring and layout planning.
• Compact Board Size – Practical footprint for small enclosures, automation builds, and permanent soldered prototypes.

📊 Technical Specifications

• Board Type: Double-sided prototyping PCB board
• Board Size: approx. 70 × 50.1 mm
• Weight: approx. 9.45 g
• Module Footprint Side 1: ESP-12 style SMD pads
• Module Footprint Side 2: ESP32 style SMD pads
• Prototype Hole Pitch: 2.54 mm standard spacing
• Compatible Modules: ESP-12E, ESP-12F, ESP07, ESP32, ESP32S, ESP8266-based circuits
• Pad Layout: SMD module footprints with surrounding through-hole prototype pads
• PCB Colour: Green
• Mounting: Corner mounting holes

🧩 Typical Applications

• ESP-12E and ESP-12F WiFi projects
• ESP07 external antenna module builds
• ESP32 IoT development
• Relay automation circuits
• Sensor interface boards
• Smart home control projects
• Permanent soldered builds from breadboard circuits
• DIY electronics prototyping

⚠️ Important Notes

• This is a bare PCB only; no ESP module, relay, headers, or electronic components are included.
• The ESP-12 and ESP32 SMD footprints are on opposite sides of the board.
• Only populate the module footprint required for your project.
• Confirm ESP07, ESP-12, and ESP32 pinout compatibility before soldering.
• External voltage regulation and ESP boot-mode pull-up or pull-down resistors may be required depending on the module used.
• Relay loads require suitable driver circuitry and safe wiring practices.

📦 Package Includes

• 1 × 5x7cm Double Sided ESP12 ESP32 Prototyping PCB Board

🔗 Recommended Accessories (Not Included)

• ESP-12E or ESP-12F module – compact WiFi control projects
• ESP07 module – external antenna WiFi applications
• ESP32 module – WiFi and Bluetooth development
• 2.54 mm header pins – prototyping connections and module wiring