Sold out
A4988 Step Stick Stepper Motor Driver Module With Heatsink 3D Printer $6.76 - $7.95 Inc. GST
LM8UU Linear Ball Bearing, Fits 8mm Shaft - For RepRap Prusa / Mendel 3D Printer $3.36 - $3.95 Inc. GST

Out of stock


$5.85 Inc. GST

Out of stock


This DRV8825 Stepper Motor Driver Module is an upgrade of A4988. Use for replacing the A4988 to upgrade your 3D printer.
Highest support 32 subdivision.
Can interface directly with 3.3V and 5V systems.
4-layer, 2 oz copper PCB for improved heat dissipation.
Small chip resistance, with low heat and good heat radiation feature.
Built-in regulator (no external logic voltage supply needed).
Adjustable current control lets you set the maximum current output with a potentiometer, you can use a voltage that is higher than the stepper motor’s rated voltage to achieve higher step rates.
Intelligent chopping control automatically selects the correct current decay mode (fast decay or slow decay).
Overheating closed circuit, under voltage lockout, cross current protection.
Grounding short circuit protection and load short circuit protection.
Exposed solderable ground pad below the driver IC on the bottom of the PCB.
Module size, pinout, and interface match those A4988 stepper motor driver carriers in most respects.

Six different step resolutions: full-step, half-step, 1/4-step, 1/8-step, 1/16-step, and 1/32-step
Maximum Supply Voltage: 45V
Maximum Current: 2.5A
Drive Current: 2.5A
Size: 1.5mm x 2mm

Package includes:
1x DRV8825 Stepper Motor Driver
1x Heat Sink

Weight 40 g
Dimensions 260 × 160 × 20 mm


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Your custom content goes here. You can add the content for individual product
Back to Top